Omega System Makeup and Routing Info – Type C Heads

Omega System Makeup and Routing Info – Type C Heads

This is the instructions for the Omega System Makeup Routing HUD and Makeup appliers with your mesh heads and other items that support Makeup Appliers. Not sure what sort of head you have? Find your head on the Supported Meshes List and check out the page for your particular mesh.   If you’re a Mesh Maker and need to know what type of head yours is, Click Here.


Kits with popups

As of 4/19/2017 I've started testing a new popup feature for certain mesh heads. On these mesh heads, selecting the HUD or ALL buttons on Cosmetic Appliers, or any button on a Face applier, will prompt you with a choice of location. This should reduce the need for the Generic Routing HUD but does not disable its functionality.

Because of this, I advise you set your HUD to "none" when you are not using it for routing, to avoid it triggering when you click on HUD and Makeup buttons.


Makeup Info for Type C Mesh Heads

Type C Heads are incredibly rare. There are multiple layers, each is a full head layer. For few that exist, each of these is a special snowflake and we had to pull some strings to make it work, so check your individual Meshes instructions for more information.

Makeup Testing
Regardless of what type of head you’ve purchased, a very important part of mesh head ownership is knowing where the makeup sections are. This will save you grief when you shop if you know where on the face your Makeup Areas start and stop so you can avoid purchasing an item that won’t fit on your available Makeup Zones.

To do this, look on the Router HUD and you’ll see Rainbow buttons.   These apply a rainbow texture to the selected makeup areas. Play with it and the different sections listed on the hud to see where each section is mapped. When you are done, the clear buttons will remove the rainbow from your face.


Other Uses for the Router:

The routers not just for makeup!

Installer Storage

In addition to handling Makeup Appliers, the Routing HUD also serves as a storage System for the Installers you use.  This can be handy if you have alot of different Omega Friendly Bits. To use, simple keep your Router worn whenever you Install Omega into new Meshes. Then.. the next time you need to re-install Omega, either because you got an update, or opened a fresh Mesh, or had to hit the debug button on the router menu, you can use the “Install” button in the Settings Menu and the router will install all the Meshes it remembers. 🙂

Phat Azz Applier Forwarding
It took us 2 years to get ahold of the man, but we finally did. We finally have the Channels, and most importantly the Permission from CK Winx himself to use them.  If you wear the Router and use a Phat Azz applier, it will apply to any mesh with Omega Installed. 🙂

And before you ask, no I will not do the same for <insert brand of applier here>.  We only use Channels that we have permission to use, and only in the way we’ve been granted permission to use them.  Do not pester Mesh Makers asking them to give me permission either. It’s not in their best interest to do so. Phat Azz is a unique case in that the Mesh is off the Market.